• Following the edges of the box, carefully cut slits for future areas to fold

1. Check your cuts by folding the paper over all of the different angles of the box.
2. (* Trim off any excess paper before moving on to the next step.)
3. Your paper should look something like the pictures below.

1. Take your cut up paper outside while using spray mount (it is messy and sticky, so be careful).
2. Once sprayed wait a few moments before sticking the paper onto your box.
3. Lay the paper flat on your workspace, sticky side up and begin to smooth the paper onto the box. (***This part is tricky and requires patience. If you make a mistake, slowly pull off the paper...and be careful of tearing it!)

Use your x-acto knife to cut around the areas where hinges and clasps are.